Convectronics Heaters • Sensors • Controls
Home Products Technical Information Catalog Contact us Customer Forms About us
 
 
Tubular Heaters
 
Catalog
Download Catalog
 
 
 
 
Home > Products >Tubular Heaters > Tubular Electric Heater Forming
When you need a heat source, Convectronics’ products are designed to meet and exceed all expectations!
 

Tubular Heater Products
Tubular Electric Heaters - Forming
 
Tubular Electric Heaters can be formed into a multitude of different shapes. Figures BF1 through BF28 are typical of some common designs. For orders or custom design requirements, please specify the dimensions for the figures shown or provide a drawing or sample of the desired shape.

• SL = Sheath Length
• Bends are repressed as required
• Minimum bend radius is equal to the element diameter
             
BF1 BF2 BF3 BF4
     
Click on image to enlarge   Click on image to enlarge   Click on image to enlarge   Click on image to enlarge
             
BF5   BF6   BF7   BF8
     
Click on image to enlarge   Click on image to enlarge   Click on image to enlarge   Click on image to enlarge
             
BF9   BF10   BF11   BF12
     
Click on image to enlarge   Click on image to enlarge   Click on image to enlarge   Click on image to enlarge
             
BF13   BF14   BF15   BF16
     
Click on image to enlarge   Click on image to enlarge   Click on image to enlarge   Click on image to enlarge
             
BF17   BF18   BF19   BF20
     
Click on image to enlarge   Click on image to enlarge   Click on image to enlarge   Click on image to enlarge
             
BF21   BF22   BF23   BF24
     
Click on image to enlarge   Click on image to enlarge   Click on image to enlarge   Click on image to enlarge
             
BF25   BF26   BF27   BF28
     
Click on image to enlarge   Click on image to enlarge   Click on image to enlarge   Click on image to enlarge
             
All Convectronics’ Tubular Heating Elements have the MgO insulation compacted by reducing the element diameter. The elements are then annealed in a furnace to relieve the metal stressing (work hardening) that takes place during the roll reduction of the sheath. Annealing brings the metal back to a soft state, allowing the element to be bent into virtually any configuration. However, forming also work hardens the metal so some precautions must be observed in order to prevent the sheath from breaking during bending or developing stress crack marks.
Note: Elements with tight bends and some applications require the bends to be recompacted in special dies to restore the insulation density and maintain dielectric strength.
Click on image to enlarge
             
> Back to Top            

Custom Designs

Let our experienced and knowledgeable staff assist you with
Custom Engineering, Design and Implementation of your toughest applications!
Contact CONVECTRONICS for your custom design projects.
Call Toll Free 1-800-633-0166
     
Custom Formed Tubular Heater Designs
   

 

 
   
Radiant Process Heaters  
   
 
   
  Tubular Heaters for Hot Runner Manifolds
   
 
 
 
 
 
 
 
     
> Back to Top    
     
 
 

Home | Products | Technical Info | Catalog | Contact | About | Sitemap
Copyright © 2007 Convectronics