Convectronics Heaters • Sensors • Controls
Home Products Technical Information Catalog Contact us Customer Forms About us
 
 
Tubular Heaters
 
Catalog
Download Catalog
 
 
 
 
Home > Products >Tubular Heaters > Tubular Electric Heaters Mounting Methods
When you need a heat source, Convectronics’ products are designed to meet and exceed all expectations!
 
spacer

Tubular Heater Products
Tubular Electric Heaters - Mounting Methods
 

 
 
Bushings
Sheath
Diameter		 Bushing
Thread Size 		Hex
Dimension		 A
.250” 1/2-20 3/4 1"
.312” 1/2-20 3/4 1"
.375” 5/8-1/8 1 1"
.430” 3/4-16 1 1"

A threaded bushing is brazed or welded to the sheath to provide quick, rigid, liquid or air-tight mounting through tank walls, oven walls, etc.

• Available in Brass or Stainless Steel
• All bushings furnished with plated washer,
  compressed non-asbestos gasket and jam nut
• Hex head bushings are standard
• Specify location from end of sheath

  
 
 
 
 
 
 
 
    Click on image to enlarge
     
Locator Rings  
Locator rings are permanently attached to the heater sheath and are used to limit the movement of the heater while allowing for expansion and contraction of the heater sheath. When ordering, please specify the location from the end of the sheath.  
     
Mounting Brackets  
The 16 gauge stainless steel mounting bracket is an economical way to mount the heater in non-pressurized, non-liquid applications. Unless otherwise specified the brackets will be located 1/2” (13 mm) from the edge of the heater sheath.

 

 
    Click on image to enlarge
* All letter designated dimensions must be supplied by the customer.
 
> Back to Top    

 
 

Home | Products | Technical Info | Catalog | Contact | About | Sitemap
Copyright © 2007 Convectronics